Lomanco C416 16-Inch X 4-Inch Mill Finished Undereave Vent16″ x 4″

The new Lomanco Deck-Air Intake Vent is now available!The Deck-Air, Model DA-4, is a shingle over roof deck installed intake vent, for detailed information on this exciting new product, please visit our Deck-Air specialty page.

Inadequate intake is the #1 cause of attic ventilation system failure. Specifically, inadequate intake results in extreme heat buildup in the summer and severe weather infiltration and moisture problems in the winter.

The intake system must provide as much as or more than the exhaust system in Net Free Area.

Proper vent chutes should be installed before blown-in insulation to prevent choking your intake system. A good rule of thumb is to place one between each set of rafter tails in order to maximize intake air.

If maintenance free vinyl/metal under eave panels are used, the vented panels should be installed continuously around the under eave portion of the house.

If the under eave width prohibits the use of cornice or strip vents neveruse an exhaust louver as an intake vent. The most logical solution would be to install SV-10 Starter Vent or the Deck-Air Roof Deck Installed Intake Vent.

The 105 Continuous Soffit Vent, SV-10 Starter Vent, and CV-4 Cirk-L-Vents are also available in copper.

Lomanco C-Series Cornice Vents
All-aluminum construction.
8×8 perma-coated aluminum screen attached.
Pre-drilled nail holes.
Unique “Eyebrow” designed louvers provide maximum ventilating capacity with superior weather protection.
Cornice-mounted companion product for all types of exhaust ventilators.

House-Hasson